X-90 (4WD) L4-1591cc 1.6L SOHC MFI (1998)
/l4-1591cc_1.6l_sohc_mfi/Page-920001.png)
Load Compensator: Testing and Inspection
FLUID PRESSURE TEST
Before testing the LSPV, confirm that the fuel tank is filled with fuel and the vehicle is equipped with its spare tire, tools, jack and jack handle.
1. Place vehicle on level floor and set 100 kg (221 lbs.) weight slowly on axle housing center.
2. Install special tool to front and rear brake.
NOTE: Special tool No. 09956-02310 should be connected to breather of front (left side brake) and rear brakes.
3. Depress brake pedal gradually until fluid pressure of the front brake becomes as specified below and check corresponding pressure of rear brake
then. It should be within the specification given.
^
As done above, apply 100 kg/cm2 pressure to front brake and check that rear brake pressure then is within the specifications given.
4. If the rear brake pressure is not within specification, adjust it by changing bolt "A" tightening position as follows.