X-90 (4WD) L4-1591cc 1.6L SOHC MFI (1998)
Ignition Cable: Testing and Inspection
1) Disconnect high-tension cord at ignition coil while gripping its cap.
2) Remove distributor cap installed with high tension cords.
3) Pull out high-tension cords from spark plugs while gripping each cap.
CAUTION:
-
It is recommended to check high-tension cords without unclamping their clamps so as to avoid damage to their inside wire (resistive
conductor).
-
For the same reason, pull out each connection by gripping cap.
4) Measure resistance of high-tension cord by using ohm meter.
High-tension cord resistance: 10 - 22 k Ohms/m, 3.0 - 6.7 k Ohms/ft
5) if resistance exceeds specification, inspect distributor terminal and replace high-tension cord(s) and/or distributor cap as required.
CAUTION:
-
Never attempt to use metal conductor high-tension cords as replacing parts.
-
Insert each cap portion fully when installing high-tension cords.