X-90 (4WD) L4-1591cc 1.6L SOHC MFI (1998)
Seals and Gaskets: Service and Repair
Removal and Replacement
REMOVAL
1. Remove rear axle shaft.
2. Remove rear axle shaft inner oil seal.
INSTALLATION
1. Using special tools (A & B) drive in oil seal until it contacts oil seal protector in axle housing.
NOTE:
^
Make sure that oil seal is free from inclination as it is installed.
^
Refer to figure so that oil seal is installed in proper direction.
Special Tool:
(A): 09924-74510
(B): 09944-68210
"A": Grease 99000-25010 or equivalents.
2. For procedure hereafter, refer to rear axle shaft.