XL-7 2WD V6-3.6L (2007)
Brake Master Cylinder: Removal and Replacement
Master Cylinder Reservoir Replacement
Master Cylinder Reservoir Replacement
Removal Procedure
WARNING:
Refer to [Brake Fluid Irritant Caution].
CAUTION:
When adding fluid to the brake master cylinder reservoir, use only GM approved or equivalent DOT-3 brake fluid from a clean, sealed
brake fluid container. The use of any type of fluid other than the recommended type of brake fluid may cause contamination which could
result in damage to the internal rubber seals and/or rubber linings of hydraulic brake system components.
CAUTION:
Refer to [Brake Fluid Effects on Paint and Electrical Components Notice].
1. Remove the underhood electrical center bracket.
2. Remove the brake fluid from the reservoir. Discard the fluid into an approved container.
3. Disconnect the brake fluid level sensor electrical connector.