XL-7 2WD V6-3.6L (2007)
9. Using GE-47851, install the compressor clutch to the compressor.
10. Using a feeler gauge, check the clearance between the compressor clutch and the compressor pulley. Ensure the clearance is 0.3 mm to 0.6 mm
(0.012 in to 0.024 in).
11. Once the correct air gap is obtained, install the new clutch bolt.
12. Using J 37872 to hold the compressor clutch, tighten the clutch bolt.
Tightening torque
Tighten the bolt to 20 N.m (15 lb.ft).
13. After the clutch bolt is installed, verify that the compressor pulley spins freely.
14. Install the compressor to the vehicle. Refer to [Compressor Replacement].
