XL-7 2WD V6-3.6L (2007)
CAUTION:
Refer to Fastener Notice.
3. Connect the power steering cooler pipe fitting (1) to the power steering gear.
Tightening torque
Tighten to 25 Nm (18 ft. lbs.).
4. Compress the power steering cooler pipe clamp (1) and connect the power steering cooler pipe (2) to the remote power steering fluid reservoir.
5. Clean any excess fluid from the vehicle and remove the drain pans.
6. Install the left side engine splash shield.
7. Install the front tire/wheel assemblies.
8. Install the air cleaner outlet duct.
9. Install the fuel injector sight shield.
10. Fill and bleed the power steering system.