XL-7 2WD V6-3.6L (2007)
WARRANTY CLAIM INFORMATION
Repair Instructions:
NOTE:
Important:
When programming a new or existing RCDLR, the programming instructions in the Service Manual must be followed.
^
After replacement or reprogramming of the RCDLR, the tire type and tire pressures must be selected in the module set-up using the Tech 2®. If
this step is not performed, the RCDLR will not retain the tire pressures after the TPM system is learned.
Tip:
When selecting the Tire Type/Pressure choose the appropriate selection on the Tech 2 based on psi not kPa.
^
Relearn the TPM sensors using the TPMS Test Tool 09945-86510 and following the procedure found in Service Manual.
^
After the learn procedure is complete, be sure to set the tire pressures according to the information on the tire placard.
1.
Reprogram the RCDLR with the latest software update available through TIS2WEB.
Important:
New transmitters are identified by a star on the back of the transmitter. It is important to verify that the replacement transmitters have a star on the
back.
2.
Replace both Remote Keyless Entry transmitters.
3.
Program the transmitters using the procedure listed in the service manual.
4.
Perform the following steps in the exact order:
4.1
Remove the key from the ignition.
4.2
Open and close the driver's door.
4.3
Close all other doors/trunk/liftgates.
4.4
Wait 5 minutes.
4.5
Press the Unlock Button and verify that the doors all unlock.
