XL-7 2WD V6-3.6L (2007)
2. If available, remove the yellow retaining tab (1) from the SIR steering wheel module coil and save the tab for reassembly.
3. Hold the SIR steering wheel module coil face up by the casing (2).
a. Slowly turn the SIR steering wheel module coil hub (3) clockwise until the coil ribbon stops.
b. Slowly rotate the SIR steering wheel module coil hub (3) counterclockwise 2.5 revolutions until the centering window (4) turns yellow. This
indicates the CENTER position.
NOTE: If the retaining tab is not available, the use of tape to secure the SIR steering wheel module coil is recommended for installation to the
steering column.
4. Install the yellow retaining tab (1) to the SIR steering wheel module coil.
5. Slide the centered SIR steering wheel module coil onto the steering shaft.