XL-7 2WD V6-3.6L (2007)
Tie Rod End: Service and Repair
Steering Gear Inner Tie Rod Replacement - Off Vehicle
Steering Gear Inner Tie Rod Replacement - Off Vehicle
Disassembly Procedure
1. Remove the steering gear boot.
2. Place the steering gear in a vise.
CAUTION:
Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear
preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.
3. Bend the tabs to release the retaining washer (1).
CAUTION:
Refer to [Pipe Wrench Positioning Notice].
4. Place a pipe wrench on the rack next to the steering linkage inner tie rod housing (2).
5. Place a wrench on the flats of the steering linkage inner tie rod housing (2).
6. Rotate the steering linkage inner tie rod housing (2) counterclockwise while holding the rack stationary until the steering gear inner tie rod
separates from the rack.
7. Remove and discard the retaining washer (1).
Assembly Procedure