XL-7 4WD V6-2.7L (2003)
Rear Door Panel: Service and Repair
Rear Door Trim Panel Removal and Installation
1. Remove inside handle bezel (1).
2. Remove inside lock knob and door inside pull handle case fitting screw.
3. Remove window regulator handle (if equipped). To remove regulator handle, pull off snap ring by using a cloth as shown in the figure.
4. Remove door trim (1) with inside weather-strip. With inside handle bezel (2) tilted as shown in the figure, turn door trim (1) 90 degrees
counterclockwise to remove it. And disconnect power window switch lead wire.
Reverse removal procedure to install Door Trim Panel.