XL-7 4WD V6-2.7L (2003)
3) Using special tool (flare nut wrench), loosen flare nuts (1) and disconnect brake pipes (2) from ABS hydraulic unit/control module assembly (3).
Special Tool: 09950-78220
NOTE: Put bleeder plug cap onto pipe to prevent fluid from spilling. Do not allow brake fluid to get on painted surfaces.
4) Remove three bolts and take out ABS hydraulic unit/control module assembly (1) from bracket using flat end rod or the like (2).
CAUTION:
^
Do not give an impact to hydraulic unit.
^
Use care not to allow dust to enter hydraulic unit.
^
Do not place hydraulic unit on its side or upside down. Handling it in inappropriate way will affect its original performance.
Installation