XL-7 4WD V6-2.7L (2003)
CAUTION:
^
Do not pull wire harness when removing front wheel speed sensor.
^
Do not cause damage to surface of front wheel speed sensor and do not allow dust, etc. to enter its installation hole.
7. Remove brake disc
NOTE: If brake disc can not be removed by hand, use 8 mm bolts as shown in the figure.
8. Remove stabilizer bar.
9. Disconnect tie rod end (1) from knuckle (2) by using puller (3).
10. Support lower arm (1), using jack (2) as shown in the figure.
12. Remove strut bracket bolts (1).
13. Remove ball stud castle nut.
