XL-7 4WD V6-2.7L (2003)
Suspension Strut / Shock Absorber: Testing and Inspection
Rear Shock Absorber Inspection
Check
^
Inspect for deformation or damage.
^
Inspect bushings for wear or damage.
^
Inspect for evidence of oil leakage.
^
Replace any defective part.
WARNING: When handling rear shock absorber in which high-pressure gas is sealed, make sure to observe the following precautions.
^
Don't disassemble it.
^
Don't put it into the fire.
^
Don't store it where it gets hot.
^
Before disposing it, be sure to drill a hole in it where shown by an arrow in the figure and let gas and oil out. Lay it down sideways for
this work.
^
The gas itself is harmless but it may issue out of the hole together with chips generated by the drill. Therefore, be sure to wear goggle.
Drill hole diameter
"A": Approximately 3 mm (0.12 inch)