XL-7 4WD V6-2.7L (2003)
9. Remove floor jack from axle housing and connect breather house onto axle housing and clamp it securely.
10. Connect brake pipes onto axle housing and clamp them securely.
11. Connect brake flexible hose to bracket on axle housing and secure it with E-ring.
12. For vehicle without ABS, install LSPV stay to axle housing, tighten LSPV stay bolt to specified torque. And adjust LSPV.
Tightening torque
LSPV stay bolt (a): 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
13. Connect brake pipe to brake flexible hose and tighten brake pipe flare nut to specified torque.
Tightening torque
Brake pipe flare nut (b): 16 Nm (1.6 kgf-m, 11.5 ft. lbs.)
14. Clean mating surface of axle housing (1) (right and left) and brake back plate, then apply sealant "A" as shown in the figure.
"A": Sealant 99000-31110
15. Apply grease "A" to axle shaft inner oil seal lip as shown in the figure.
"A": Grease 99000-25010
16. Install rear axle shaft to rear axle housing.
