XL-7 4WD V6-2.7L (2003)
"A": Grease 99000-25010
3. Install transmission boot No. 1 (1) from inside of cabin and clamp it with a new clamp (2) securely.
4. Install transfer boot No. 1 (1) securely on lift and clamp it by using a new clamp (2).
5. Tighten transmission boot No. 2 with boot cover (2) and console box bracket (1).
Tightening torque
Control lever boot cover bolt (a): 6 Nm (0.6 kgf-m, 4.5 ft. lbs.)
6. Install console box.
NOTE: Be sure that flare end of transmission boot No. 3 (3) is engaged with console box.
Inspection
^
Check shift control lever lower portion and control lever locating sheet for excessive wear.
^
Check boot for damage. Correct or replace if necessary.
