XL-7 4WD V6-3.6L (2008)
CAUTION: Refer to [Fastener Notice].
3. Install the CMP actuator solenoid valve bolt.
Tightening torque
Tighten the bolt to 10 N.m (89 lb.in).
4. Connect the engine wiring harness electrical connector (5) to the bank 1 exhaust CMP actuator solenoid valve.
5. Install the air cleaner assembly. Refer to [Air Cleaner Assembly Replacement].
Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake
Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake