XL-7 4WD V6-3.6L (2008)
![background image](/suzuki/xl-7_4wd/v6-3.6l/Page-1062131.png)
3. Prepare the splice. Untwist the conductors and follow the splicing instructions for copper wire. Staggering the splices by 65 mm (2.5 in) is
recommended.
NOTE: Apply the mylar tape with the aluminum side inward. This ensures good electrical contact with the drain wire.
4. Re-assemble the cable.
^
Rewrap the conductors with the mylar tape.
^
Use caution not to wrap the drain wire in the tape (1).
^
Follow the splicing instructions for copper wire and splice the drain wire.
^
Wrap the drain wire around the conductors and tape with mylar tape.
5. Tape over the entire cable. Use a winding motion when you apply the tape.
Wiring Repairs
Wiring Repairs
The Wiring Repairs section contains the following types of wiring repair information. Using these elements together will make wiring repair faster and
easier:
^
Testing for Intermittent Conditions and Poor Connections
^
Flat Wire Repairs
^
GMLAN Wiring Repairs
^
High Temperature Wiring Repairs
^
Heated Oxygen Sensor Wiring Repairs
^
Splicing Copper Wire Using Splice Clips
^
Splicing Copper Wire Using Splice Sleeves
^
Splicing Twisted or Shielded Cable
^
Splicing Inline Harness Diodes
^
SIR/SRS Wiring Repairs