XL-7 Limited 4WD V6-2.7L (2002)
Installation
1. Install brake back plate (3) to rear axle shaft (1).
2. Apply sealant "A" to joint seam of rear axle housing (1) and brake back plate.
"A": Sealant 99000-31110
NOTE: Make sure to remove old sealant before applying it anew.
3. Install rear axle shaft to rear axle housing.
4. Tighten brake back plate nuts to specified torque.
Tightening torque
Brake back plate nut (a): 50 Nm (5.0 kgf-m, 36.5 ft. lbs.)
5. Install wheel cylinder, and tighten wheel cylinder bolts and brake pipe flare nut (or nuts) to specified torque.
Tightening torque
Wheel cylinder bolt (b): 13.5 Nm (1.35 kgf-m, 10.0 ft. lbs.)
Brake pipe flare nut (c): 16 Nm (1.6 kgf-m, 12.0 ft. lbs.)
