XL-7 Limited 4WD V6-2.7L (2002)
into groove in cylinder taking care not to twist it.
Piston and boot
1. Before inserting piston into cylinder, install boot (1) onto piston (2) as shown in the figure.
2. Fit boot as it is in figure into boot groove in cylinder with fingers.
Check to make sure that boot is fitted into boot groove in cylinder completely in its circumference.
3. Insert piston into cylinder by hand and fit boot in boot groove in piston.
4. To confirm that boot is fitted in its groove in cylinder properly, pull piston out of cylinder a little but do not take it all out.
5. Install piston into cylinder by hand.
6. Install anti noise shim (if equipped).
Caliper