XL-7 Limited 4WD V6-2.7L (2002)
11. Remove exhaust No.1 pipe (1).
12. Remove exhaust manifold stiffeners (1).
13. Remove stabilizer bar mounting bolt and pull down stabilizer bar if right side exhaust manifold is removed.
14. Remove exhaust manifolds and their gaskets from cylinder heads.
Installation
1. Install new manifold gaskets to cylinder heads and No. 1 pipe gasket to exhaust No. 1 pipe.
2. Install exhaust manifolds.
^
Always install new bolts with pre-coated adhesive to the locations with * mark.
^
Tighten both manifold nuts and bolts to specified torque.
Tightening torque
Exhaust manifold bolt and nut (a): 30 Nm (3.0 kgf-m, 21.5 ft. lbs.)
3. Install stabilizer bar if it was removed.
4. Install exhaust manifold stiffeners.
