XL-7 Limited 4WD V6-2.7L (2002)
8. Remove circlip using special tool.
Special tool
(A) : 09900-06107
9. Remove magnet clutch coil (1).
Installation
1. Install magnet clutch coil (2).
NOTE: Protrusion on under side of magnet clutch coil (2) must match hole in compressor assembly (3) to prevent movement and correctly locate
lead wire.
2. Using special tool, install new circlip (1) as shown.
Special tool
(A) : 09990-06107
3. Install clamp portion and ground terminal of lead wire.
4. Install magnet clutch (1).
a. Set magnet clutch squarely over clutch installation boss.
b. Place special tool onto clutch bearing. Ensure that edge rests only on inner race of bearing.
Special tool
