XL-7 Limited 4WD V6-2.7L (2002)
Air Bag Control Module: Service Precautions
Precautions on Handling and Storage of SDM
WARNING: Never power up air bag system when SDM is not rigidly attached to the vehicle. Otherwise, personal injury may result.
CAUTION: After detecting one time of such collision as to meet deployment conditions, the SDM must not be used. Refer to "Air Bag Diagnostic
System Check: "when checking the SDM.
-
Never attempt disassembly of SDM.
-
When storing SDM, select a place where neither high temperature nor high humidity is anticipated and oil, water and dust are kept off.
-
If SDM has been dropped, replace it with a new one.
-
If installation part of SDM was damaged, repair that part completely before reinstallation.
-
All SDM and mounting bracket fasteners must be carefully torqued and the arrow must be pointed toward the front of the vehicle to ensure proper
operation of the air bag system.
WARNING:
SDM
-
During service procedures, be very careful when handling a Sensing and Diagnostic Module (SDM). Never strike or jar the SDM.
Never power up the air bag system when the SDM is not rigidly attached to the vehicle. All SDM and mounting bracket fasteners must be carefully
torqued and the arrow must be pointing toward the front of the vehicle to ensure proper operation of the air bag system.
The SDM could be activated when powered while not rigidly attached to the vehicle which could cause deployment and result in personal injury.
