XL-7 Limited 4WD V6-2.7L (2002)
a. [In case of driver air bag (inflator) module]
i.
Clear a space on the ground about 185 cm (6 ft) (3) in diameter where the driver air bag (inflator) module (1) is to be deployed. A paved,
outdoor location where there is no activity is preferred. If an outdoor location is not available, a space on the shop floor where there is no
activity and sufficient ventilation is recommended. Ensure no loose or flammable objects are within the deployment area.
ii. Place the driver air bag (inflator) module (1), with its vinyl trim cover facing up (2), on the ground in the space just cleared.
b. [In case of passenger air bag (inflator) module]
i.
Clear a space on the ground about 185 cm (6 ft) (2) in diameter where the fixture (special tool) with attached air bag (inflator) module (1)
is to be placed for deployment. A paved outdoor location where there is no activity is preferred. If an outdoor location is not available, a
space on the shop floor where there is no activity and sufficient ventilation is recommended. Ensure that no loose or flammable objects are
within the deployment area.
ii. Place special tool (passenger air bag (inflator) module deployment fixture) on the ground in the space cleared in step a), if it has not
already been placed there.
iii. Fill plastic reservoir in fixture (special tool) with water or sand. This is necessary to provide sufficient stabilization of the fixture during
deployment.
iv. Attach the passenger air bag (inflator) module in the fixture (special tool) using mounting attachment, hold- down bolts and nuts and M8
bolts and nuts (1).
CAUTION: Be sure to use the following bolt and nut for fixing passenger air bag (inflator) module to mounting attachment.
Size: M8, Strength: 7T
