XL-7 Limited 4WD V6-2.7L (2002)
7. Remove coil spring (1).
Installation
1. Install coil spring (3) on spring seat (2) of axle housing (1) and then raise axle housing (1).
NOTE: When seating coil spring, mate spring end with stepped part (4) of rear axle spring seat (2) as shown in the figure.
2. Install shock absorber lower bolt. For its proper installing direction, refer to the figure.
NOTE: Nut should not be tightened.
3. Install wheel speed sensor clamp (if equipped) and E-ring, and connect breather hose to axle housing.
4. Connect parking brake cable hanger (1) to chassis frame (4) and clamp (3) to cross member (2). Remove floor jack from axle housing.