XL-7 Limited 4WD V6-2.7L (2002)
4. Pass and connect interlock cable (1) as shown in the figure.
5. For selector lever side
a. With key release cam (2) set as shown in figure, connect inner end (1) of interlock cable to key release cam.
b. Move key release cam (1) so that it is set at such angle as shown in figure and with special tool inserted in hole A, fix key release cam (1).
Special tool
(A): 09925-78210 (6 mm)
c. With key release cam (1) fixed with special tool, install cable outer (2) to bracket and after making sure that cable outer is pushed in arrow
direction B by leaf spring, tighten mounting nut to specified torque. Remove special tool.
Tightening torque
Interlock cable outer mounting nut (a): 13 Nm (1.3 kgf-m, 9.5 ft. lbs.)
6. Turn ignition key to "ACC" position and shift select lever to "N" range, and check for the followings.
a. When select lever is shifted at "P" range with knob button depressed, ignition key can not be turned from "ACC" to "LOCK" position.
b. When knob button is released, ignition key can be turned to "LOCK" position.
c. When ignition key is at "LOCK" position, select lever can not be shifted from "P" to any other range.
7. Install console box.
8. Install steering column cover.
9. Adjust steering column or tighten steering column bolts.
10. Install steering column hole cover.
11. If equipped with air bag system, enable air bag system.
