XL-7 Limited 4WD V6-2.7L (2002)
Axle Shaft: Service and Repair
Rear Axle Shaft and Wheel Bearing Removal and Installation
Removal
1. Remove rear brake drum (1).
2. Drain gear oil from rear axle housing by loosening drain plug (1).
3. Remove rear wheel bearing retainer nuts (1) from axle housing.
4. Remove wheel speed sensor (1) from rear axle housing (if equipped with ABS).
CAUTION:
^
Do not pull wire harness or twist more than necessary when removing rear wheel speed sensor.
^
Do not cause damage to surface of rear wheel speed sensor or pole piece and do not allow dust, etc. to enter its installation hole.
