XL-7 Limited 4WD V6-2.7L (2002)
10.
To repair cuts after the inspection process spread a small amount of 3M SCOTCH-GRIP # 4475 PLASTIC ADHESIVE on the cuts flatly by using
a plastic paddle applicator. Note: Follow warnings and cautions on adhesive label and ensure that the cuts are covered by the glue.
11.
Place black tape on top of adhesiveto cover cuts. Repeat steps (4) to (11) for left side of vehicle. Remove masking tape and reinstall cowl grille
and windshield wiper arms.
12.
Install the Blue EC Recall Campaign sticker to the flat surface on the upper radiator support just next to the hood latch and bumper. This will
identify that the inspection has been completed.
Disclaimer
