XL-7 Plus 2WD V6-2.7L (2001)
Vehicle Speed Sensor: Testing and Inspection
DIAGNOSIS - SPEEDOMETER AND VSS
ON-VEHICLE INSPECTION
1. Hoist vehicle.
2. Release parking brake lever, set transmission in neutral and transfer in "2H".
3. Remove ECM (PCM) cover.
4. Connector voltmeter between VSS terminal C51-3-1 of ECM (PCM) connector and body ground.
5. Turn ignition switch ON and turn rear right tire slowly with rear left tire locked.
Voltmeter should indicate deflection between 0 - 1 V and 8 - 14 V a few times while tire (1) is turned one revolution. If check result is not
satisfactory, proceed to flow table of "DTC P0500".
