XL-7 Standard 2WD V6-2.7L (2001)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
REMOVAL
1. Disconnect reservoir lead wire at coupler.
2. Clean outside of reservoir (1).
3. Take out fluid with syringe or such.
4. Remove reservoir stopper (3).
5. Remove reservoir (1).
NOTE: Do not allow brake fluid to get on painted surfaces.
INSTALLATION
NOTE: See NOTE at the beginning of this section.
1. When using new grommets, lubricate them with the same fluid as the one to fill reservoir (1) with. Then press-fit grommets to master cylinder (2).
Grommets must be seated in place.
2. Install reservoir (1) and then insert stopper (3).
3. Connect reservoir lead wire.
4. Fill reservoir (1) with specified fluid.
