XL-7 Standard 2WD V6-2.7L (2001)
Wheel Cylinder: Service and Repair
INSTALLATION
For the details, refer to the same item of the same section in the service manual mentioned in the FOREWORD of this manual noting the following
points.
^
Take off bleeder plug cap from brake pipe and connect pipe (or pipes) to wheel cylinder (1) just enough to prevent fluid from leaking.
^
Tighten wheel cylinder to brake back plate (1) to specified torque.
Tightening torque
Wheel cylinder bolt (for non sealed type) (a): 13.5 Nm (1.35 kg-m, 10.0 ft. lbs.)
