XL-7 Standard 2WD V6-2.7L (2001)
3.
Apply sealant "B": Suzuki Bond 1207B (# 99104-31140) to the mating surfaces of the cylinder heads and cylinder block as shown. Use a plastic
scraper as a jig to force the sealer into the air gap formed by the cylinder head, block and head gasket as shown in call-out "A" below. There are
four areas "B" where this must be performed.
NOTE:
Failure to perform this step will result in oil weepage/seepage that will migrate down the front side of the engine block. This may appear and
be misdiagnosed as a crankshaft oil seal leak.
Disclaimer