XL-7 Standard 2WD V6-2.7L (2001)
LSPV specification
4. As done step 3), apply 100 kg/cm2 pressure to front brake and check that rear brake pressure then is within specification as given.
LSPV specification (applied 100 kg/cm2 pressure to front brake):
5. If rear brake pressure is not within specification, adjust it by changing stay (3) position as follows.
Tightening torque
LSPV stay bolt (a): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
^
If rear brake pressure is higher than specification, move stay to direction "a" and if it is lower, to direction "b".
^
Repeat steps 4) and 5) until rear brake pressure is within specification.
^
After adjustment, be sure to torque bolt to specification.
6. Disconnect brake pipe (connecting between master cylinder secondary side and 4-way joint) from master cylinder. Tighten plug (special tool) to
master cylinder. Depress brake pedal. If rear brake pressure is 95 - 100 kg/cm2 when front brake pressure is 100 kg/cm2, it means that front
fail-safe system functions properly.
LSPV specification (for fail-safe system function check):
Special tool
(A): 09956-02210
