XL-7 Standard 2WD V6-2.7L (2001)
Air Bag Control Module: Service and Repair
SDM
WARNING: During service procedures, be very careful when handling a Sensing and Diagnostic Module (SDM). Be sure to read "Service
Precautions". before starting to work and observe every precaution during work. Neglecting them may result in personal injury or inactivation
of the air bag system when necessary.
REMOVAL
1. Disconnect negative (-) cable at battery.
2. Disable air bag system.
3. Remove rear and front center console box (1) by removing screw and clips.
4. Remove center garnish panel (2).
5. Remove ashtray (3) and tuner assembly, clock assembly (5), tuner pocket, radio hole cover (4), etc.
6. Disconnect SDM connector (1) from SDM (2).
7. Remove SDM (2) from vehicle.
INSTALLATION
1. Check that none of following faulty conditions exists.
-
Bend, scratch, deformity in vehicle body mounted on SDM
-
Foreign matter or rust on mating surface of vehicle body mounted on SDM
