XL-7 Standard 4WD V6-2.7L (2002)
Brake Switch (Cruise Control): Testing and Inspection
Stop Lamp Switch (With Pedal Position Switch) Inspection
1. Disconnect negative cable (-) at battery.
2. Disconnect stop lamp switch connector and remove stop lamp switch from pedal bracket.
Stop Lamp Switch (With Pedal Position Switch) Specification
3. Check switch (two contacts) for resistance under each of the following each conditions. If check result is not satisfactory, replace stop lamp switch.
4. Install stop lamp switch and adjust its position referring to "Brake Light Switch Adjustment:".
