XL-7 Standard 4WD V6-2.7L (2002)
7. Apply sealant "A" to LH bank exhaust camshaft housing No.5 sealing surface area as shown in the figure.
"A": Sealant 99000-31150
8. Check position of LH bank camshaft housings.
Embossed marks are provided on each camshaft housing, indicating position and direction for installation. Install housings as indicated by these
marks.
9. After applying oil to housing bolts, tighten them temporarily first.
Then tighten them by following sequence ("1" - "17") as indicated in the figure. Tighten a little at a time and evenly among bolts and repeat
tightening sequence 2 or 3 times before they are tightened to specified torque.
Tightening torque
Camshaft housing bolt: 12 Nm (1.2 kgf-m, 9.0 ft. lbs.)
10. Install 1st timing chain.
11. Install LH bank 2nd timing chain.
12. Install timing chain cover.
13. Install oil pan.
14. Install front differential housing.
15. Install P/S system.
16. Install cooling system.
17. Install intake manifold with throttle body.
18. Install CMP sensor.
19. Refill cooling system with coolant, front differential with gear oil, P/S system with specified fluid and engine with engine oil.
20. Check wheel alignment.
21. Verify that there is no fuel leakage, water leakage and oil leakage at each connection.
22. Check ignition timing.
CAUTION:
