XL-7 Standard 4WD V6-2.7L (2002)
8. After applying oil to housing bolts, tighten them temporarily first.
Then tighten them by following sequence ("1" - "17) as indicated in the figure. Tighten a little at a time and evenly among bolts and repeat
tightening sequence 2 or 3 times before they are tightened to specified torque.
Tightening torque
Camshaft housing bolt: 12 Nm (1.2 kgf-m, 9.0 ft. lbs.)
9. Install timing chain guide No.3 (1).
Tightening torque
Timing chain guide No.3 bolt (c): 11 Nm (1.1 kgf-m, 8.0 ft. lbs.)
10. Install 1st timing chain.
11. Install LH bank 2nd timing chain.
12. Install timing chain cover.
13. Install oil pan.
14. Install front differential housing.
15. Install P/S system.
16. Install cooling system.
17. Install intake manifold with throttle body.
18. Refill cooling system with coolant, front differential with gear oil, P/S system with specified fluid and engine with engine oil.
19. Check wheel alignment.
20. Verify that there is no fuel leakage, water leakage and oil leakage at each connection.
