XL-7 Standard 4WD V6-2.7L (2002)
-
Do not deploy/activate two or more air bag system components (air bag (inflator) modules and seat belt pretensioners) at the same time.
-
Never connect deployment harness to any power source before connecting deployment harness to the air bag (inflator) module and seat belt
pretensioner. Deployment harness shall remain shorted and not be connected to a power source until the air bag is to be deployed and the
pretensioner is to be activated.
Deployment/Activation Inside Vehicle
Use this procedure when scrapping the entire vehicle including the air bag (inflator) modules and seat belt pretensioners.
CAUTION: When vehicle itself will be used again, deploy/activate the air bag and pretensioner outside vehicle according to "Deployment/Activation
Outside Vehicle", for deploying/activating it inside will cause the instrument panel, glove box and their vicinity to be deformed.
Failure to observe this CAUTION may require unneeded vehicle inspection and repair.
1. Turn ignition switch to "LOCK" position, remove key and put on safety glasses.
2. Remove all loose objects from front seats and instrument panel.
3. [For driver air bag (inflator) module]
Disconnect contact coil connector (1) located near the base of the steering column.
[For passenger air bag (inflator) module]
Remove glove box from instrument panel and disconnect passenger air bag (inflator) module connector (2).
[For seat belt pretensioner]
Remove both side (driver and passenger side) front pillar lower trim and disconnect seat belt pretensioner connectors (3).
4. Confirm that each air bag (inflator) module is securely mounted.
5. Check that there is no open, short or damage in special tool (deployment harness). If any faulty condition is found, do not use it and be sure to use
new deployment harness.
Special tool
(A): 09932-75030
6. Short (1) the two deployment harness leads together by fully seating one banana plug into the other.
WARNING: Deployment harness shall remain shorted and not be connected to a power source until the air bag is to be deployed and
seat belt pretensioner is to be activated.
