XL-7 Standard 4WD V6-2.7L (2002)
-
The air bag (inflator) module and seat belt pretensioner immediately after deployment/activation is very hot. Wait for at least 30 minutes to cool it
off before proceeding the work.
-
Do not apply water, oil, etc. to deployed air bag (inflator) module and to activate seat belt pretensioner.
-
After an air bag (inflator) module has been deployed, the surface of the air bag may contain a powdery residue. This powder consists primarily of
cornstarch (used to lubricate the bag as it inflates) and by-products of the chemical reaction. As with many service procedures, gloves and safety
glasses should be worn.
-
Wash your hands with mild soap and water after completing the work.
Refer to the procedure described under "Deployed Air Bag (Inflator) Module and Activated Seat Belt Pretensioner Disposal" for disposal.
Precautions on Disposal of Air Bag and Seat Belt Pretensioner
Do not dispose of the live (undeployed) air bag (inflator) modules and the live (inactivated) seat belt pretensioners.
When disposal is necessary, be sure to deploy/activate the air bag and seat belt pretensioner according to deployment/activation procedure described in
"Air Bag (Inflator) Module and Seat Belt Pretensioner Disposal".
WARNING: Failure to follow proper air bag (inflator) module and seat belt pretensioner disposal procedures can result in air bag deployment
and pretensioner activation which could cause personal injury. Undeployed air bag (inflator) module and inactivated seat belt pretensioner
must not be disposed of through normal refuse channels.
The undeployed air bag (inflator) module and inactivated seat belt pretensioner contain substances that can cause severe illness or personal
injury if the sealed container is damaged during disposal.
