XL-7 Standard 4WD V6-2.7L (2002)
Apply sealant mating surface "A" of axle shaft drive flange (1), then install axle shaft drive flange and tighten flange bolt (2) to specified
torque.
Tightening torque
Axle shaft drive flange bolt (a): 50 Nm (5.0 kgf-m, 36.5 ft. lbs.)
"A": Sealant 99000-31090
^
For 2WD vehicle
Remove grease, old sealant and dusts from mating surfaces of hub cap (1) and hub (2) to clean, apply water tight sealant to cap mating surface
evenly, and install cap (1) to hub (2).
"B": Sealant 99000-31090
12. Install wheel.
Tightening torque
Wheel nut (a): 100 Nm (10.0 kgf-m, 72.5 ft. lbs.)
13. For vehicle equipped with ABS, perform driving test.
