XL-7 Standard 4WD V6-2.7L (2002)
Wheel Hub / Bearing / Oil Seal Installation
1. Insert new stud in hub hole. Rotate stud slowly to assure serrations are aligned with those made by original bolt.
2. Install new sensor rotor by using special tools (if equipped with ABS).
NOTE: Use care not to insert wheel hub diagonally.
Special tool
(D): 09952-86510
(E): 09924-74510
Wheel speed sensor rotor installing position (reference dimension "a")
"a": 4.9 ± 0.1 mm (0.19 ± 0.004 inch)
3. Install wheel hub component to spindle supporting wheel bearing inner race by finger as shown in the figure.
CAUTION: Don't tap wheel hub component by hammer or the like. Otherwise, it will be broken.
NOTE: When it is impossible to install wheel hub component by hand, which means the inner race is out of alignment, remove wheel hub
component once and reinstall it.
