XL-7 Standard 4WD V6-2.7L (2002)
NOTE: When installing rear axle shaft, be careful not to cause damage to oil seal lip in axle housing.
17. Tighten bearing retainer nuts to specified torque.
Tightening torque
Bearing retainer nut (a): 50 Nm (5.0 kgf-m, 36.5 ft. lbs.)
18. For vehicle with ABS, tighten wheel speed sensor bolt to specified torque.
Tightening torque
Wheel speed sensor bolt (a): 21 Nm (2.1 kgf-m, 15.5 ft. lbs.)
19. Connect brake pipes to wheel cylinders (right and left) and tighten brake pipe flare nuts to specified torque.
Tightening torque
Brake pipe flare nut (a): 16 Nm (1.6 kgf-m, 11.5 ft. lbs.)
20. Install brake drum (right and left).
21. Refill rear axle housing with new specified gear oil.
22. Fill reservoir with brake fluid and bleed brake system.
