XL-7 Standard 4WD V6-2.7L (2002)
Four Wheel Drive Selector Switch: Service and Repair
Transfer 4WD Switch Removal and Installation
1. Remove console box and lift transmission control lever boots No. 2 and No. 3.
2. Remove transfer control lever boot No. 2 (3), unclamp wiring on transfer case to free it and pull off coupler (1).
3. Replace 4WD switch (2)and connect as it was.
Tightening torque
4WD switch (a): 20 Nm (2.0 kgf-m, 14.5 ft. lbs.)
4. Turn ON ignition switch, shift transfer shift control lever to 4WD position and check that indicator lights. Turn OFF switch after checking.
NOTE:
^
When removing and reinstalling switch, use care not to let dust enter transfer box inside.
^
Make sure to reset clamp for wiring which is located where invisible directly.
^
It is recommended to work on transfer shift control lever boot No. 1 from underside of vehicle on lift.
^
Identify 4WD switch (2) by its leg part which is different for that of back up light switch (1).
