XL-7 Touring 4WD V6-2.7L (2002)
Starter Armature: Testing and Inspection
Armature Shaft Bush
Inspect bush for wear or damage. Replace if necessary.
Armature
-
Inspect commutator for dirt or burn. Correct with sandpaper or lathe, if necessary.
-
Check commutator for uneven wear with armature (1) supported on V-blocks (2). If deflection of dial gauge pointer exceeds limit, repair or
replace.
NOTE:
Below specification presupposes that armature is free from bend. Bent armature must be replaced.
Commutator out of round
Standard: 0.05 mm (0.002 in.) or less
Limit: 0.4 mm (0.016 in.)
