XL-7 Touring 4WD V6-2.7L (2002)
-
When installing circlip (1) to drive shaft, utilize screw hole in drive shaft to pull it out and bring large diameter (2) of circlip (1) at right as
shown.
-
When installing axle shaft drive flange (1) to wheel hub, apply sealant "A" to mating surface of axle shaft drive flange (1) and tighten flange
bolt (2) to specified torque.
"A": Sealant 99000-31090
Tightening torque
Axle shaft drive flange bolt (a): 50 Nm (5.0 kgf-m, 36.5 ft. lbs.)
-
Check that no foreign material is attached to sensor and rotor. Install wheel speed sensor (1) and its harness clamp (2).
Tightening torque
Wheel speed sensor harness clamp bolt (a): 10 Nm (1.0 kgf-m, 7.5 ft. lbs.)
Wheel speed sensor bolt (b): 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
CAUTION:
^
Do not pull wire harness or twist more than necessary when installing front wheel speed sensor.
^
Fit harness grommet to inner fender securely.
Check that there is no clearance between sensor (1) and knuckle (2).
