XL-7 Touring 4WD V6-2.7L (2002)
Drive/Propeller Shaft: Service and Repair
Propeller Shaft
Disassembly
1. Using special tool (A), remove 2 circlips.
Special tool
(A): 09900-06108
2. Using special tool (B), push spider bearing race out 3 - 4 mm (0.12 - 0.16 inch) from shaft yoke race.
NOTE: Before pushing it out, apply penetrate lubricant between bearing race and yoke race.
Special tool
(B): 09926-48010
Spider bearing race installing position (length "a") "a": 3 - 4 mm (0.12 - 0.16 inch)
3. Tapping yoke with a hammer, completely remove bearing race.
4. Take out bearing race on the other side in the same way as in Step 2 and 3).