XL-7 Touring 4WD V6-2.7L (2002)
5. Push out bearing race on flange yoke side as described in Step 1 and 2), and then, holding bearing race in a vise (1), tap flange yoke and take out
race. (Refer to the figure.)
Remove bearing race on the opposite side in the same way.
NOTE:
^
Take care not to lose rollers in spider bearing race when removing it.
^
Fit removed bearings temporarily in spider so that they can be reinstalled in their original positions.
Reassembly
NOTE:
^
Before assembly, inspect the parts.
^
Make sure that rollers inside spider bearing race are all in place.
^
Make sure to apply grease to spider bearing race.
"A": Grease 99000-25030
CAUTION: In assembly, be sure to use new circlips, spider (1) and bearings (2). Reuse of circlips, spider (1) and bearings (2) once assembled is
prohibited.
