toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Drivetrain - High Pitched Noise From Propeller Shaft|Page 2125 > < Drivetrain - Drive/Axle Shaft Replacement Precautions
Page 1
background image

Drive/Propeller Shaft: All Technical Service Bulletins
Drivetrain - High Pitched Noise From Propeller Shaft

 DRIVELINE/
REFERENCEDIFFERENTIAL
NUMBER

005

DATE

11-30-90

MODEL

RN01, RN02, RN37,
VN94, VN01, VN02, VN39

TITLE:

PROPELLER SHAFT HIGH PITCH NOISE

Some vehicles may exhibit a whistle type noise while driving in any of the forward gears at speeds below 50 mph. The propeller shaft has been identified
as the probable source of the whistle noise.

To diagnose and identify if the propeller shaft is the source of the whistle noise, (for testing) install two rubber exhaust (donuts) hangers (p/n
90301-34207) approximately 18 inches from each end of the shaft. If, after installing the rubber exhaust hangers, the speed range changes or level of the
whistle noise is reduced the propeller shaft is the source of the whistle noise (see illustration below).

Correction:

Replace the propeller shaft with the new paper lined propeller shaft (see illustration below). The application chart and part
number information is on page 2.

VEHICLE INFORMATION:

Drivetrain - High Pitched Noise From Propeller Shaft|Page 2125 > < Drivetrain - Drive/Axle Shaft Replacement Precautions