4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
3. Disconnect brake lines.
Using Special Service Tool (SST) # 09023-00100, disconnect the 6 brake lines.
Torque: 15 Nm (11 ft. lbs.)
4. Remove master cylinder.
Remove the 2 mounting nuts, 4-way, check valve bracket, bracket and pull out the master cylinder and gasket.
Torque: 13 Nm (9 ft. lbs.)
DISASSEMBLY
1. Remove reservoir.
(a) Remove the set screw and pull out the reservoir.
Torque: 1.7 Nm (18 kg.cm, 16 inch lbs.)
(b) Remove the cap and strainer from the reservoir.
2. Remove 2 grommets.
3. Place cylinder in vise.
4. Remove piston stopper bolt.
Remove Piston Stopper Bolt
Using a screwdriver, push the pistons in all the way and remove the piston stopper bolt and gasket.
NOTE: Tape the screwdriver tip before use.
Torque: 10 Nm (7 ft. lbs.)
5. Remove 2 pistons and springs.
