4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
Using an ohmmeter, measure the resistance.
Maximum resistance: 25 K ohms per cord
If the resistance is greater than the maximum, check the terminals. If necessary, replace the high-tension cord.
6. Reconnect high-tension cords to ignition coils
(a) Assemble the holder and grommet.
(b) Align the spline of the ignition coil with the spline of the holder, and push in the cord.
NOTICE: Check that the holder is correctly Installed to the grommet and ignition coil as shown in the illustration.
(c) Check that the lock claw of the holder is engaged by lightly pulling the holder.
7. Reconnect high-tension cords to spark plugs.
Secure the high-tension cords with the clamps as shown in the illustration.
8. Reinstall intake air connector.
9. Reinstall air cleaner cap and MAF meter assembly.
