4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
Rotor: Testing and Inspection
Rotor
1. INSPECT ROTOR FOR OPEN CIRCUIT
Using an ohmmeter, check that there is continuity between the slip rings.
Standard resistance (Cold):
2.1 -2.5 Ohms
If there is no continuity, replace the rotor.
2. INSPECT ROTOR FOR GROUND
Using an ohmmeter, check that there is no continuity between the slip ring and rotor.
If there is continuity, replace the rotor.
3. INSPECT SLIP RINGS
a. Check that the slip rings are not rough or scored. If rough or scored, replace the rotor.
b. Using a vernier caliper, measure the slip ring diameter.
Standard diameter:
14.2 - 14.4 mm (0.559 - 0.567 in.)
Minimum diameter:
12.8 mm (0.504 in.)
If the diameter is less than the minimum, replace the rotor.
